![]() If the vacuum is not currently cleaning, how long it cleaned for in its last run.Ĭleaning progress - Only available on some newer devices - what percent of the current cleaning is completed.ĭock error - Only available on the non-basic docks - The current error of the vacuum or ‘Ok’ if none exist If the vacuum is not currently cleaning, how much area it has cleaned during its last run.Ĭleaning time - How long the vacuum has been cleaning for. SensorĬleaning area - How much area the vacuum has cleaned in its current run. ![]() Water shortage - States if the water box is low on water - ‘Ok’ if it has not detected a water shortage. Water box attached - States if the water box is currently attached. Mop drying status - Only available on docks with drying capabilites - States if the mop is currently being driven. Mop attached - States if the mop is currently attached. This is on when the robot is actively moving around or when the robot returns to the dock when the battery is low but a clean is still active and will resume later. Binary sensorĬleaning - States if the vacuum has a clean currently active. Mop intensity - How hard you would like your vacuum to mop. On some firmware, it is called ‘mop route’. ![]() ![]() Mop mode - Describes how to mop the floor. The vacuum entity holds the ability to control most things the vacuum can do, such as start a clean, return to the dock, or set the fan speed. Only entities that your device supports will be added to your integration. Roborock devices have a variety of features that are supported on some devices but not on others. If the above My button doesn’t work, you can also perform the following stepsįollow the instructions on screen to complete the setup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |